carbon 3 toe rubbing
hi i have the carbon 3 black in size 9 uk but atm they are rubbing my left little toe something bad can only skate a few hours untill ir hurts too much tried it with thicker socks but that didn't help at all heat molded them about 3 or 4 times now and still nothing do you reckon getting half a size up will help?
if the outside of your pinky toe is getting rubbed, feel inside the skate, i'd bet you can feel the edge of the shell through the padding. mine are like that, not much you can do but ad more padding really. or pad your foot somehow.
just had a look but there was still padding around there but i could feel a seam that might cause it. luckily gettign a replacement pair next week so getting half a size up hopefully this will help
buy a heat gun and spot heat mold. just don't burn your skate like a dummy!
i had that exact problem. i put in an extra footbed to lift my foot just above that carbon. zero problems since.
Originally Posted by julien vie
will try that marshun just put a normal insole under the usd one?
The exact same shit happened to my pair. Sold em and bought Valos. No more pain, no more flimsy soul plates.
Yea sounds good man.
My Deshi Carbons where like this, seam was stitched way too high and poorly at the front and rubbed the left side of my foot and toe. Was like a mini hacksaw. Fucking painful.
Powerslide replaced them no questions asked.
nah i put a better insole on top of the usd one. skates just get a tad more snug too. you could probably just take some out of some shoes you got and try it out. thats what i tried and then i went and got some good insoles
i had same problem and what i did is put super thick insoles to lift my foot away from the bad stitch, they fit me hella snugged almost hurt then heat molded again and again to release pressure on toe...plush now
getting my skates repalced mid next week so will see if they any different gone half a size up just incase
Posting Permissions
Reply With Quote
Bookmarks