valo toecut size

[SGCharas]

hi guys, i'm reading all post in this forum, but still have a question!
this is my situation, i've valo tv3 shell eu43/eu44 with jug black sox eu43. in this shell i fit good with valo liner and if i buy the previus shell i've the six toe like remz and too much pressure point. but my jug not fit good in this shell, it's too short when i put the liner in my skate. in other skate the black sox is good.
grindhouse told me: 2/3 session and maybe your liner stretch forward without toecut. the jug black sox eu43 can fit an eu43/eu44 shell of valo tv3. is it the true?
if i have to cutting the toe area, I don't want more space, only a bit of length for stretch the liner correctly!
i don't want my eu43 becomes an eu44 or eu45, i don't want the liner slide forward when i skate!
your opinion?i make the toe cut or i don't?
thanks a lot, Stefano

[SGCharas]

another option can be buy an eu43 of trust special ops liners and put it into my 43/44 shell. in grindhouse they write this:

"Attention: These liners will not fit properly if you size them true in standard hardboot skates (Valo Standard & Remz excluded, here you size them true into the regular shellsize, check the "Sizing Conversion" image"

can be a good and comfortable setup valo tv shell 43/44 and trust special ops eu43?
always grindhouse write me that an eu43 of jug black sox and an eu43 of trust special ops, have the same lenght.
so i can fit good without oversize the liners, right?
anyone that use special ops in the same size of shell?